Konica Minolta 7085/FORCE 85 Service Manual page 790

Caution:
If the PU-108+the Finisher cannot be aligned
correctly with the main body, adjust the height of
the casters on the paper-exit side of the Finisher.
Adjust inclination.
(3) Fix the PU-108+the Finisher to the main body.
When fixing the unit, tighten the knob screw (1
pc.) and the lower screws (TP screw M4x8: 2
pcs.) in sequence.
(4) Return the paper guide of the PU-108 to its
original position (by pushing down the lever).
7. Secure the PU-108 and the Finisher (lower front
Caution:
8. Push the pin of the positioning plate into the
Caution:
Knob screw
TP screws
(M4x8)
E-8
side). (TP screw M4x6: 2 pcs.)
Be sure to secure the main body and the PU-108
+the Finisher before tightening the screws to secure
the PU-108 and Finisher to each other.
TP screws (M4x6)
connecting part of the PU-108 and Finisher, and
secure the positioning plate with screws. (TP screw
M4x6: 2 pcs.)
Secure the PU-108+the Finisher to the main body,
then install the positioning plate.
Positioning plate
TP screws (M4x6)