Fns Adjusting The Stapler Vertical Positioning (Fs-108/108Bm/211 Only) - Konica Minolta 7085/FORCE 85 Service Manual

OTHER ADJUSTMENT
3. Adjustment Procedure
(1) Loosen the 3 set screws holding the flat-stapling
stopper bracket in place, and position the bracket
so that distance A is within the specification
range.
Spec range: A = 5.5 to 11.5mm
(initial value = 8.5mm)
(2) Hold paper against the stoppers and confirm that
all three stoppers are in alignment.
(3) Execute stapling to confirm that the stopper line
and stapler line are parallel.
MODEL
7075/7085
SERVICE HANDBOOK
Adjust.
Scale Scale
Scale
MANUAL REVISED EDITION
[27] FNS Adjusting the Stapler Vertical
3
Positioning (FS-108/108BM/211 only)
1. Tools used
• Screwdriver (Phillips)
• Jig (special tool)
2. Preparation
(1) When replacing or reinstalling a stapler or clincher,
adjust the vertical alignment as described below.
3. Adjustment Procedure
(1) If installing a stapler, mount the stapler into place.
(2) Loosely fasten the clincher in place with 4 screws.
(If the clincher is already fastened in place, loosen
the 4 screws so that you can adjust it.)
(3) Remove the plate from the jig.
Jig
DATE
1 - 138
Jan. 2002
3
Jig positioning
Plate section
Guide pins
PAGE METHOD
1-138 REPLACEMENT