Replacing The Vertical Conveyance Roller (Upper); Removing And Reinstalling The Vertical; Conveyance Rollers (Middle/Lower) - Konica Minolta 7085/FORCE 85 Service Manual

VERTICAL CONVEYANCE SECTION
[3] Replacing the Vertical Conveyance
Roller (Upper)
Caution: Be sure the power cord has
been unplugged from the wall
outlet.
a. Procedure
(1) Remove the vertical conveyance section.
(2) Remove the E-ring to remove the gear and pin.
(3) Remove the two E-rings to move the bearing
outward.
(4) Remove the vertical conveyance roller (upper).
E-ring
Pin
Gear
E-ring
Caution: Install the gear with the shaft pin fit into
the groove at the back of the gear.
(5) Reinstall the above parts following the removal
steps in reverse.
E-ring
Bearing
Vertical
conveyance roller
Gear
Pin
3 - M - 2
[4] Removing and Reinstalling the
Vertical Conveyance Rollesrs
(Middle/Lower)
Caution: Be sure the power cord has
been unplugged from the wall
outlet.
a. Procedure
(1) Remove the vertical conveyance section.
(2) Remove vertical MCs 9 and 10.
(3) Remove the two E-rings to move the bearing.
(4) Remove the vertical conveyance rollers (middle/
lower) together with the shaft.
Caution: This illustration shows how to remove
the vertical conveyance roller (middle).
Remove the vertical conveyance roller
(lower) in the same manner.
Bearings
E-ring
(5) Reinstall the above parts following the removal
steps in reverse.
E-ring
Vertical conveyance
roller (lower)
Vertical conveyance
roller (middle)