Konica Minolta 7085/FORCE 85 Service Manual page 744

[Adjustment for skew]
Move the set position of the positioning pin at the
LCT bottom plate (Fig. 15).
Fig. 15
Positioner
V. Alteration of the Paper Size
The default paper size is A4 or 8.5 x 11. If paper size
is to be altered to B5, go to the following procedures.
(1) Open the Top cover of the LCT.
(2) Loosen the screws of the Paper guide side
plates, and secure it again adjusting to the
marking line for the altered paper size (Fig. 16).
Fig. 16
(3) Loosen the screw of the bottom plate to adjust
the marking line to the altered paper size and
secure it again (Fig. 17)
Fig. 17
Screws
B5
16K
8.5X11
A4
(4) Set the End guide plate to the end of the paper
stack.
(5) Turn the Main Switch ON pressing the ten key
[2] and [5] simultaneously.
(6) Select "x Paper size setting" menu on the LCD
and change the paper size to the altered one.
VI. Installation of the Operation manual
holder
Glue the Operation manual holder with the double
coated adhesive tape and secure it with 2 bind screws
(M3 x 6) (Fig. 18).
Note:
The installation of the Operation manual holder is
alternative between the Main body and the LT-401.
Fig. 18
E-4
Operation manual
holder
Adhesive tape