CLEANING/TONER RECYCLE UNIT
[5] Replacing Guide Plate Assembly
Caution: Be sure the power cord has
been unplugged from the wall
outlet.
a.
Procedure
(1) Remove the toner guide brush.
(2) Remove one E-ring, and one cleaning unit
mounting lever collar.
(3) Remove two screws to detach the drive shafts
support palte.
(4) Remove the cleaner drive gear A assembly.
(5) Remove the cleaner drive bearing and the
plunging prevention felt.
Caution: Once the plunging prevention felt is
removed, replace it.
(6) Remove one E-ring from the toner guide shaft,
then the cleaner drive gear B.
(7) Remove one E-ring from the toner guide shaft,
then the paper feed bearing.
Toner guide
shaft
Cleaner
bearing
Plunging
prevention
felt
Cleaner drive
gear A
assembly
3 - I - 6
E-ring
Paper feed
bearing
Cleaner drive
gear B
E-ring
Cleaning unit
mounting lever
collar
Drive shaft
support plate
Screw
(B tight M3x8)
E-ring
Screw
(TP M3x6)