Replacing The Cleaning Web; Replacing The Fixing Heater Lamps (Upper/Roller) (L2, L3) - Konica Minolta 7085/FORCE 85 Service Manual

FIXING UNIT

[3] Replacing the Cleaning Web

a. Procedure
(1) Draw out the ADU stand. (See "ADU UNIT.")
(2) Open the fixing unit top cover.
(3) Remove the two screws to detach the cleaning
web unit.
Cleaning web unit
Screws (2)
(4) Reinstall the above parts following the removal
steps in reverse.
Caution 1: When installing the cleaning web,
align the groove in the take-up gear
with the shaft pin on the unit,
keeping its tension.
Caution 2: After replacing the cleaning web,
make sure to reset the count value
of the fixing unit cleaning web by
"Copy Count by Parts to be
Replaced (Fixed Parts)" in the 25
mode.
MODEL
7075/7085
SERVICE HANDBOOK
Pin
Gear groove
MANUAL REVISED EDITION
[4] Replacing the Fixing Heater Lamps
(Upper/Roller) (L2, L3)
Caution: Do not touch the fixing heater
Caution 1: Install the heater lamp with the
Caution 2: The heater lamp should not touch
Caution 3: When replacing a heater lamp, be
a. Procedure
(1) Remove the fixing unit from the main body.
(2) Open the fixing unit top cover.
(3) Remove the two screws at the front to detach the
two wire harness clamps.
Caution: Install the wiring clamp screws
through the lower mounting holes. If
installed through a wrong mounting
hole, the fixing unit front cover cannot
be installed.
(4) Remove one screw and detach the lamp fixing
3
plate cover. (7085 only)
(5) Remove the two screws to detach the front lamp
fixing plate.
(6) Remove the two Faston terminals.
Front lamp fixing plate
DATE
3 - O - 2
Jan. 2002
3
lamp with bare hands.
maker mark indication side facing
front.
the inner surface of the upper
roller.
sure to insert the lamp end in the
lamp terminal securely.
Wiring
harness
clamps (2)
Faston
terminals (2)
Faston terminals
(remove 2)
PAGE METHOD
3-O-2 REPLACEMENT
7075
Screws
(2)
Screws
(2)