Konica Minolta 7085/FORCE 85 Service Manual page 768

2. Remove the Control board cover (for FORCE75/
DP75).
(1) Remove the Upper cover by removing 8 screws.
Upper cover
(2) Remove the Cover support plate (left) by
removing 2 screws.
Cover support plate (left)
(3) Remove the Control board cover by removing
6 screws.
Control board cover
3. Install the Memory unit in one of the Control board
slots CN115, CN116 or CN117.
Note:
The first installation of the optional Memory unit is
recommended to install in the CN115 slot in order
to leave the easiness for full installation (3 Memory
units) or future installation.
Note:
MU-401 and MU-402 can be installed in the
combination.
CN 115 CN 116 CN 117
In 7085, this part looks different in shape
Caution:
• Install the Memory unit meeting its cutout
properly to the slot on the Control board.
• On the installation, open both clamps of the slot,
and insert the Memory unit, tilting for 45 degrees
against the Control board, until clicking the
clamps.
In 7085, this part looks different in shape
4. Reinstall the removed parts in the reversed
procedure.
E-2