Fns Adjusting The Magnets On Conveyance Guide Plate C - Konica Minolta 7085/FORCE 85 Service Manual

[13] FNS Adjusting the Magnets on
Conveyance Guide Plate C
1. Tool used
• Screwdriver (Phillips)
2. Preparation
(1) Open the front cover.
(2) Check whether conveyance guide plate C makes
contact with the cushioning rubber when the
magnets are stuck to conveyance guide plate D.
(3) If conveyance guide plate C does not make
contact with the cushioning rubber, remove the
rear cover and carry out adjustment as described
below.
3. Adjustment Procedure
(1) Detach all FNS CB (FNS control board) connec-
tors.
(2) Remove the 2 set screws holding the FNS CB in
place. Remove the FNS CB together with its
bracket.
Bracket
(3) Loosen the 4 magnet-holding set screws (two at
the front and two at the back), and move convey-
ance guide plate C all the way in the direction
indicated by the arrow.
FNS CB (Finisher Control Board)
Screws
(4) Adhere the magnets to conveyance guide plate A
and retighten the screws.
Magnet
(rear)
(5) Reassemble in opposite sequence to removal.
1 - 125
OTHER ADJUSTMENT
Conveyance Guide Plate C
Magnet
(front)
Conveyance
Guide Plate D