Replacing The Up/Down Plate Wires - Konica Minolta 7085/FORCE 85 Service Manual

PAPER FEED UNITS OF TRAYS 1 AND 2

[9] Replacing the Up/Down Plate Wires

Caution 1: This section explains how to replace the rear wires. To replace the front wires, remove the
front cover of tray and paper up/down unit. The replacement procedure is the same as that
for the rear wires.
Caution 2: When replacement or reinstallation of the wires is complete, check whether the up/down
plate moves up and down smoothly by rotating the up/down plate drive pulley by hand.
Caution 3: Be sure to install wires so that they do not cross nor ride over each other.
Caution 4: After installing the wires, adjust inclination of the up/down plate.
<Removing Wires>
(1) Remove the up/down unit.
(2) Draw out paper feed tray 1/2.
(1) Remove the E-ring to slide
out the drive pulley.
Wire D
Wire A
(Black)
Wire C
Drive pulley
E-ring
(2)(4) Remove the retaining
ring to detach the wire
regulation cover and pulley.
Wire B
(Black)
(3) Remove
wire C.
Wire C
3 - J - 6
Wire
regulation
cover
Pulley
Retaining ring
Wire D
(5) Remove wire D.
Wire C
Wire D