Konica Minolta 7085/FORCE 85 Service Manual page 760

3. Remove the screws from the Main body. (TP screw
M4x6: 4 pcs.)
4. Install 2 LCT Fixing plates on the Main body with
the screws (TP screw M4x8: 4 pcs.) from the
accessory parts for each plate.
LCT Fixing plates
5. Reinstall the cover at the bottom of the right side
of the Main body. (2 screws)
6. Cut the 9 places on the cover where paper passes
through using a nipper or other appropriate device.
Cut out these areas.
7. Install Earth plate 2 (2 plates) on the Main Body
with the screws (TP screw M4x6: 2pcs.) from the
accessory parts.
8. Remove the cover at the back of the right side of
the Main body (2 screws).
9. Cut out the Earth plate 1 cover (4 places) and
Connector cover (6 places) using a nipper or other
appropriate device.
Cut out these areas.
10. Remove screws from the cover at the back of the
right side of the Main body.
Caution:
Do not lose the washers because they will be used
again.
E-2
Earth plate 2
TP screws M4x6
Right side
cover (back)
Washers