Konica Minolta 7085/FORCE 85 Service Manual page 269

(5) Open the jam access guide plate to remove the
paper reverse/exit switchover gate.
Gate drive
E-ring
fitting
Screw
Bering
Bearing
E-ring
Movable guide plate
Paper
reverse/exit
switchover gate
(6) Reinstall the above parts following the removal
steps in reverse.
Caution: When installing the paper reverse/exit
Loosen the two paper reverse/exit switchover
gate installation adjustment screws.
Stack fifteen plain papers (64g/m
them between the gate and the paper guide
plate, then tighten the adjustment screws.
3 - N - 23
switchover gate, must perform the
following adjustment.
Reversal/paper exit
switchover gate
Paper guide
plate
ADU UNIT
Gate installation
adjustment
screws (2)
2
) and insert