Tu Trimming Parallelism Adjustment; Adjusting The Pz Paper Path Switching Solenoid - Konica Minolta 7085/FORCE 85 Service Manual

[34] TU Trimming Parallelism Adjustment

1. Tools
• Screwdriver (Phillips)
2. Adjustment Method
Front door
Mark
Screws
Step
1 Measure the lengths of the upper edge (A)
and lower edge (B) of the trimmed booklet
to obtain the parallelism.
Parallelism = A - B
Folding edge
2 Open the front door.
3 Raise the press release lever.
4 Loosen the two screws.
5 Adjust the conveyance guide plate assem-
bly according to the mark so that the par-
allelism is within the spec.
Standard: less than ±1 mm
6 Tighten the two screws securely.
MODEL
7075
SERVICE HANDBOOK
Press release lever
Conveyance guide
plate assembly
Operation
A
Trim edge
B
MANUAL REVISED EDITION
[35] Adjusting the PZ Paper-Path
Switching Solenoid
1. Tools
• Screwdriver (Phillips)
2. Adjustment Method
Registration guide plate
Gate SD/L (SD1) OFF
Screw (for
bracket)
OFF
Screw (for bracket)
Gate SD/L (SD1) ON
ON
DATE
1 - 145
Sep. 2001
OTHER ADJUSTMENT
Gate/L
Gate SD/L (SD1)
Registration guide plate
Screws (for solenoid)
PAGE METHOD
1-145 REPLACEMENT