Konica Minolta 7085/FORCE 85 Service Manual page 706

1. Place the wooden spacers under the Adjuster
feet. Then extend the Adjuster feet enough to
remove the cushions with the spanner (Not
attached to the accessory box) (Fig. 05).
Fig. 05
Spanner
Adjuster foot
2. Remove the cushions. Then wind up the Adjuster
feet again to let the machine descend onto the
pallet. Be sure to work on the above steps 1 and
2 in succession, respectively for the right side
and left side of the machine.
3. Fix the veneer with 2 nails at the right end face of
the pallet, setting its beveled portion upward (Fig.
06).
Fig. 06
Corrugated fiberboard
4. Set the 4 cushions and 4 wooden spacers
removed from the machine, below the veneer as
illustrated below. (Fig. 07).
Fig. 07
Corrugated
fiberboard
Cushions
Wooden spacer
Nail: 2pcs
Veneer
2 Spacers
(A) (D) or (E)
Veneer
(A) (D) or (E)
2 Spacers
Cushion rear (A)
Cushion front (D, E)
Cushion left (B, C)
5. Bring down the machine carefully on the floor by
two persons (Fig. 08).
Fig. 08
Caution : Precautions for moving the main
body
Confirm that the Adjuster feet are fully wound up
before moving the machine.
IV. Accessories Packed with the Main Body
1. Wooden spacers
2. Operation manual holder
3. Ventilation duct
4. Developer (For U.S.A only)
5. Cotton swabs
6. Setup report (For U.S.A only)
7. Unpacking and installation manual
8. Operation manual (Other than Europe)
9. Operation sheet (French) / (For Europe only)
10.Operation sheet (German) / (For Europe only)
11.Operation sheet (Italian) / (For Europe only)
12.Operation sheet (Spanish) / (For Europe only)
13.Nails
14.Veneer
15.Bind screws M3 x 6 : 2pcs.
16.Printer relay wiring / 1
17.Cable tie
18.Mounting clamp : 2pcs.
E-2