Krds Set Up - Konica Minolta 7085/FORCE 85 Service Manual

[14] KRDS Set Up

Step
1 Turn off the modem, connect the copier to the
modem using a modem cable, and connect the
modem to a wall jack using a modular cable.
(see *4.)
2 Set the copier software DIP switch 15-5 (KRDS
connection recognition) to "1".
(25 mode →
1
Initialize KRDS memory. (47 mode →
3
→ Start button ON)
9 8 P
4 Turn off the main switch of the copier.
5 Set the KRDS software switch.
(25 mode →
10
→
KRDS software switch setting)
4
(Select type of modem and dial mode:
Select type of modem with the bit number 0
to 6 of KRDS software SW No. 1;
select dial mode with the bit number 7.)
6 Set the host password.
(25 mode →
10
word setting)
(See *1 and *2.)
7 Set the KRDS phone number.
(25 mode →
10
ephone number setting)
(See *3.)
8 Turn off the main switch of the copier.
9 Plug the outlet in and out.
10 Turn on the modem.
11 Turn on the main switch of the copier.
12 Perform KRDS set up calling
(25 mode →
10
host for setup)
13 Press the
START
14 Check the finishing of set up.
(25 mode →
10
software switch setting)
Completes if the data on the switch No. 33 and
the bit No. 0 indicates "1" (finished.)
15 Turn off the main switch of the copier.
Operation
Software SW setting)
1
KRDS setting
KRDS setting →
Host pass-
2
KRDS setting →
3 KRDS tel-
KRDS setting →
Calling the
5
Key to start set up.
KRDS setting →
4
*1: Host password must be 5-digit.
*2: Host password 1 must be specified.
*3: For both the copier and the host side, telephone
number 1 must be specified.
*4: Refer to the manual of the modem about specifi-
cations for connecting with the modular cable.
5
P
Wall jack
1. Setting the KRDS connection recognition
(1) Insert the power supply of the copier into the plug
socket. (Keep the main switch off.)
(2) Turn on the main switch while holding both the
copy quantity setting button 2 and 5 simulta-
neously.
(3) Select
Mode Menu Screen.
(4) Select the bit No. 5 of the switch No. 15, and then
press the
ON
OFF
(5) Turn off the power switch of the copier.
Caution: Be sure to turn off, then on the power
KRDS
1 - 49
25 ADJUSTMENT
Modem
Modular cable
Software DIP switch setting in the 25
1
key
ON
: KRDS connect
: KRDS not connected
switch of the copier after setting the
software DIP switch 15-5 to ON;
otherwise, the KRDS setting menu
cannot be selected.
TEL LINE