Konica Minolta 7085/FORCE 85 Service Manual page 714

9. Connect the printer relay wiring / 1 the printer
relay board / 2
below.(Fig.36)
(1) Connect the connector of the printer relay wir-
ing / 1 to the left connector of the printer relay
board / 2. Make sure that the connector close
to the noise filter is connected with the IP-602.
(2) Attach the two mounting clamps (supplied) on
the right side of the ventilating cover, then fix
the printer relay wiring / 1 with the clamps
making sure to avoid any slackness.
Fig. 36
Printer relay board / 2
Printer relay wiring / 1
Fix with the mounting
clamps.
Noise filter
10.Extend the Adjuster feet and adjust each length
with the spanner to make the Main body level
with the floor (Fig. 37).
Fig. 37
11. Put the Operation sheet on the Operation panel.
(For Europe only)
following the procedure
VI. Operation Check
1. Load paper in each tray, then output the internal
pattern (No.16) to check the quality of the copy
image.
Check items:
Centering, Skew, Leading edge timing etc.
Adjustment:
Refer to the Service Handbook.
2. To check IP-602, reter to the Installation Proce-
dure of the IP-602.
VII. Setting the KRDS
Refer to the Service Handbook.
E-10