Removing And Reinstalling The Pre-Transfer Roller And Pre-Registration Loop Roller - Konica Minolta 7085/FORCE 85 Service Manual

ADU UNIT
(12) Remove the two E-rings and one bearing from
the ADU paper exit roller.
Bearing
(13) Remove the four E-rings, two bearings and one
bearing fitting from the pre-registration roller.
Bearing fitting
Bearing
E-rings
(14) Reinstall the above parts following the removal
steps in reverse.
E-rings
ADU paper exit roller
Bearing
E-rings
Pre-registration roller
[15] Removing and Reinstalling the Pre-
transfer Roller and Pre-registration
Loop Roller
Caution: Be sure the power cord has
Warning: The interlock which is turned
a. Procedure
(1) Draw out the ADU stand from the main body.
(2) Remove the registration motor assembly. See
[13] Removing and Reinstalling the Registration
Motor (M12) Assembly.
(3) Remove the two screws to detach the transfer
roller drive motor (M9) assembly.
Screw
3 - N - 12
been unplugged from the wall
outlet.
OFF when the front right or left
door opens/closes, should
never been turned ON forcibly
with the ADU stand drawn out.
Screw
Transfer roller drive motor
assembly