Konica Minolta 7085/FORCE 85 Service Manual page 824

(5) Return the conveyance guide pressure lever.
(6) Tighten two fixing screws.
(7) Close the left door of the trimmer unit.
Trimmer stopper adjustment
For Konica 7055/7065
[Caution]
Perform this adjustment for all paper sizes to be
used for making trimmed copies (Use two originals
for this adjustment).
1. Turn off the power of the main body.
2. Turn on the power again while pressing numeric
keypads [3] and [6] simultaneously.
3. Load applicable paper size into the main body tray.
4. Touch "[6] Finisher adjustment" on the LCD touch
screen.
5. Touch "[3] Cutting stopper position adjustment" on
the screen.
6. Touch "Copy screen" to make a trimmed copy
sample of the size loaded in step 3, then measure
the width between the fold and cut edges.
Standard: [(paper width÷2)–2]+0/–2mm
Fold edge
[Example]
Standard for A3 paper is:
[(420÷2)–2]+0/–2mm = 206~208mm
7. If the width does not fall within the standard, follow
the adjustment procedure below.
(1) Touch "[3] Cutting stopper position adjustment"
on the LCD touch screen.
(2) Select the sample size using " " " " keys on
the screen.
(3) Input the adjustment value using "+
numeric keys on the screen.
0.1mm / step
(4) Touch "SET".
(5) Make a trimmed copy sample as above in step
6, then check again the width between the fold
and cut edges.
8. Repeat the above procedure for other applicable
paper sizes.
Trimmer stopper adjustment
For Konica 7075/Force75/DP75/7085
[Caution]
Perform this adjustment for all paper sizes to be
used for making trimmed copies (Use two originals
for this adjustment).
1. Turn off the power of the main body.
2. Turn on the power again while pressing numeric
keypads [3] and [6] simultaneously.
3. Load applicable paper size into the main body tray.
4. Touch "[6] Finisher adjustment" on the LCD touch
screen.
5. Touch "[4] Trimming stopper position adjustment"
on the screen.
6. Touch "Copy screen" to make a trimmed copy
sample of the size loaded in step 3, then measure
the width between the fold and cut edges.
Fold edge
[Example]
Cut edge
Standard for A3 paper is:
[(420÷2)–2]+0/–2mm = 206~208mm
7. If the width does not fall within the standard, follow
the adjustment procedure below.
(1) Touch "[4] Trimming stopper position
adjustment" on the LCD touch screen.
(2) Select the sample size using "NEXT ADJUST-
MENT" and "PREVIOUS ADJUSTMENT" keys
on the screen.
(3) Input the adjustment value using "+
numeric keys on the screen.
(4) Touch "SET".
–" and
(5) Make a trimmed copy sample as above in step
6, then check again the width between the fold
and cut edges.
8. Repeat the above procedure for other applicable
paper sizes.
E-6
Standard: [(paper width÷2)–2]+0/–2mm
0.1mm / step
Cut edge
–" and