Konica Minolta 7085/FORCE 85 Service Manual page 695

V. Installation Procedure
Caution:
Confirm the Main switch is OFF and the power
cord is unpluged.
1. Inspect the outward of the Main body and confirm
that there is no damage.
2. Remove the wrapping sheet on the RADF.
3. Remove the locking tapes put on the exterior pan-
els (Fig. 09).
Caution:
Locking guide tapes indicate the portions to be
unlocked; those tapes should be removed after the
completion of each unlocking procedure.
Fig. 09
Locking guide
tape
Locking tape
4. Open the RADF, and remove the glass protecting
5. Open the Bypass tray. Insert a screwdriver into
Locking tape
Locking guide
tape
Caution:
6. Remove the locking tapes within the Trays.
E-3
cushion and the glass protecting paper (Fig. 10).
Fig.10
Glass protecting paper
the guide hole of the Optics unit locking screw,
which locates on the left hand near the locking
guide tape, and then fully loosen the Optics unit
locking screw. Remove the locking guide tapes on
the Working table and the Bypass tray (Fig. 11).
The Optics unit locking screw can not be removed
but only can be loosened.
Fig. 11
Optics unit
locking screw
Red paper
(1) Open the Front door (left). Withdraw the Tray 1
while pressing the Lock lever mounted on the
left side of the Tray (Fig. 12).
Fig. 12
Lock lever
Glass protecting
cushion
Locking guide
tape
Locking guide
tape