Konica Minolta 7085/FORCE 85 Service Manual page 485

(4) Remove the cartridge, and install the plate that
you took from the jig.
Plate
(5) Install the cartridge.
Caution: Remove the remaining staples on
the upper surface. Remove the
staple sheet if it is bent.
(6) Insert the two guide pins of the jig in the guide pin
holes, and engage the end of the positioning
portion of the jig with the clincher.
Jig
Cartridge
Jig
Caution:
(7) Rotate the stapler gears downward. Adjust the
clincher position so that the plate on the cartridge
fits smoothly into the groove on the jig. Rotate the
stapler gear further to fit the plate in the groove in
the jig and the jig in the clincher unit completely.
1 - 139
OTHER ADJUSTMENT
Clincher
Clincher unit
Peg
Guide pin hole
The positioning portion of the jig
need not be engaged with the
clincher completely. Only part of
the end of the positioning portion
must be engaged so long as it is
not disengaged.
Gears