Using The Cross-Cut Function; Cutting Position; Cutting Width; Guidelines For Replacing The Cross-Cutting Unit - GRAPHTEC FC7000 Series User Manual

5.8 Using the CROSS-CUT Function

This function is used to cross-cut the media laterally to enable the completed
design to be separated from the roll.
The media is cut at a distance of 15 mm from the last data position. The minimum
length from the start of the design to the cutting position is 40 mm.
C
Cross-cutting is performed from the point that is 92 mm outside the left pinch roller
to the point that is 32 mm outside the right pinch roller. Make sure that the media
is loaded within this range.
G
• Film with a paper backing sheet:
• Film with plastic backing sheet:

Auto Cross-cutting

The media is cut automatically after the cutting or plotting operation has been
completed.
C
UTTING POSITION
UTTING WIDTH
UIDELINES FOR REPLACING THE CROSS
B A S I C F UN C T I O N S A N D O P E R A T I O N S : Us i n g t h e C R O S S -C U T F u n ct i o n
15mm
92mm
-
CUTTING UNIT
1000-mm media width: Approx. 3000 sheets
(CT01H)
1000-mm media width: Approx. 3000 sheets
(CT01H)
5-11
40 mm minimum
32mm