Setting the Cross Cut
Set whether or not to use the cross cut.
When set to the ON (used), the label that cut the contour and weeded is cross-cut near the cross cut mark when ejecting it.
The plurality of page data or label cut by selecting the COPY can be separated for each sheet.
CAUTION
•
The separator (weeding) is required to use the cross cutter.
•
The cross cutter is used to cut the backing sheet of label material that has weeded by the separator. The label material with the
backing sheet or label that stuck a laminate material may not be cut completely. At this time, the glue of the label material is attached
to the blade, or the failure of the cross-cut section may be caused. Please do not cut other than the backing sheet.
•
When set to "ON" (used), the winding function is disabled automatically.
Operation
1
CUT CONDITION & TEST screen is displayed.
2
Press the POSITION (
CONDITION (The selected item is highlighted.). Then, press
Cond No. selection screen is displayed.
3
Press the POSITION (
4
Press the POSITION (
(not used) for the cross cutter.
5
Setting will be set, and it will return to CUT CONDITION & TEST screen.
6
It will return to READY screen.
) keys to select the CUT
) keys to select the C_CUT.
) keys to set to "ON" (used) or "OFF"
2-65