FINAL DRIVE
Rear Eccentric
Rear Eccentric Installation
1.
Slide eccentric housing into swingarm with short
side toward the sprocket. The alignment tabs on
eccentric must align with slots in eccentric clamp.
2.
Turn the eccentric 1/2 turn clockwise, as viewed
from left side of machine.
3.
Install clamp bolts and tighten nuts until snug (do
not tighten at this time).
4.
Refer to axle installation on page 7.26 to install
axle.
5.
Refer to chain adjustment in Maintenance section
to adjust rear drive chain.
7/96
7.32
Polaris Industries Inc.