Table of Contents
Advertisement
FINAL DRIVE
Center Eccentric
Center Eccentric Assembly, Cont.
7.
Lubricate and install new O-rings in grooves on both
ends of shaft.
8.
Grease housing until grease begins to flow through
bearings and into seal area.
9.
Install spacers in each end large chamfer inward.
NOTE:lnstalllong spacer on long splined end of shaft.
Center Eccentric Installation
1. Thoroughly clean eccentric housing surface and
clamp housing with alcohol or lacquer thinner to
remove any grease or dirt.
2.
Install eccentric housing with long end of shaft
facing right side of machine as shown.
NOTE: Do not tap or press on eccentric shaft to install
assembly in frame. This may force seal out of housing
and cause premature bearing failure.
3.
Loosen front eccentric pinch bolt and rotate front
eccentric to loosen front drive chain.
7/96
7.36
Polaris Industries Inc.
Advertisement
Table of Contents
Troubleshooting
