Master Cylinder Installation - Polaris Magnum 2x4 Service Manual

BRAKES
Master Cyl
i
nder
Installation (Typical)
NOTE: To speed up the brake bleeding procedure the master cylinder can be purged of air before it is installed
on the brake line. Fill with DOT3 brake fluid and pump lever slowly two to three times with finger over the outlet
end to purge master cylinder of air.
1. Install master cylinder on brake line
hand tight.
2. Install master cylinder on handlebars, torquing
mounting bolts to 55 in. Ibs. (.62 Kg-m).
3. Using a line wrench, tighten brake line an additional
112 turn.
4. On models with banjo bolt, replace sealing washers
and torque bolt to specification.
5.
Fill reservoir with DOT 3 fluid.
6. Follow bleeding procedure on page 9.4.
7/96 9.20
Polaris Industries Inc.