Table of Contents
Advertisement
TRANSMISSION SERVICE
Type IV, Shaft Drive Transmission
Shaft Drive Transmission Removal
All operations regarding transmission front output housing assembly can be performed with transmission installed
in frame.
1 .
Remove the inner PVT cover. Refer to Clutch
Chapter. Remove speedometer cable.
2.
Remove
complete
airbox
assembly
and
transmission vent line.
3.
Loosen rear wheel nuts slightly.
4.
Elevate
and
support
machine
under
footrest/frame area,
CAUTION: Serious injury may result if machine tips
or falls. Be sure machine is secure before beginning
this service procedure. Wear eye protection when re-
moving and installing bearings and seals.
5.
Remove wheel nuts and wheels.
6.
Remove auxiliary brake linkage rod from caliper,
caliper, and brake disk. Support caliper on right
hand foot rest.
Disconnect transmission shift
linkage rods. Remove right hand shock absorber.
7.
Disconnect the sway bar from both sides. Remove
right side upp'er control arm.
7/96
8.18
Polaris Industries Inc.
Advertisement
Table of Contents
Troubleshooting
