Rear Eccentric Removal; Rear Eccentric Disassembly - Polaris Magnum 2x4 Service Manual

Rear Eccentric Removal
1. Remove rear axle. See page 7.24.
2. Completely remove rear eccentric pinch bolts.
3. Mark direction hub is installed for ease of
installation.
4. Rotate eccentric hub until projections line up with
slots in eccentric clamp.
5. Slide eccentric assembly out of clamp.
Rear Eccentric Disassembly
NOTE: Bearings and seals must be replaced if re-
moved.
1 . Pry out drive axle seals. Be careful not to damage
seal bore or eccentric housing.
2. Using a brass flat punch and a hammer, tap bearing
spacer sideways until loose.
3. Drive bearing outward from opposite end of
housing.
Polaris Industries Inc.
7.29
FINAL DRIVE
Rear Eccentric
5/98