Table of Contents
Advertisement
BODY AND STEERING
Headlight Pod Service (Gen IV - Typical)
Installation
1.
Install bottom of pod onto handlebar and secure
to brackets.
Do not over tighten screws or holes may strip.
2.
Install key switch, choke cable, and headlight.
3.
Connect indicator light wire coupler to indicator
lights in top half of pod.
4.
Connect speedometer cable to speedometer.
5.
Install top of pod onto bottom half, making sure
interlocking tabs mate properly.
6.
Install two front Phillips screws.
NOTE: When assembling a new pod, use the screw
to pre-thread the two front holes in the top pod before
mating halves.
7.
Install three rear Phillips screws, aligning with
Tinnerman™ clips.
8.
To adjust headlight, refer to procedure outlined
in Maintenance chapter.
10/96
5.6b
Polaris Industries Inc.
Advertisement
Table of Contents
Troubleshooting
