Front Axle Identification - Polaris Magnum 2x4 Service Manual

Polaris atv and light utility vehicle service manual

Table of Contents

Front Axle Identification

CAUTION: The left and right front drive axles are not

interchangeable. The LH side axle has the letters "LH"

stamped in the end. The axle has a left hand thread and

must be installed on the left side of the vehicle only.

replacing a front drive axle, check the

identification letters stamped on the beveled area of the

CV joint housing next to the large boot clamp.

There are different types of axles used and they are not

interchangeable. You will find either "USA" or "BTB"

stamped on the housing. Refer to the following chart

and the appropriate parts manual for the correct part

number and drive axle application.

NOTE: Reference Only Revised Parts/Microfiche Manuals

L.H. Drive Shaft Assembly with Sleeve

R.H. Drive Shaft Assembly with Sleeve

Weld Shaft Replacement

Weld Cardan Replacement

Cross and Bearing Kit

Small Band Clamp

Large Band Clamp

LH CV Housing with Sleeve

RH CV Housing with Sleeve

Drive Shaft Seal Sleeve

Kit- Repl Boot, CV Joint

Axle Identification Area

Marked USA or NEAPCO

Marked BTB on CV Be\\

Polaris Industries Inc.

Troubleshooting