Typical Pvt Disassembly - Polaris Magnum 2x4 Service Manual

Typical PVT Disassembly
CLUTCHES
PVT Disassembly
NOTE: Some fasteners and procedures will vary. Refer to the appropriate parts manual for proper fasteners and
fastener placement.
1 . Remove seat.
2. Remove six bolts and washers from the top of the rear
cab assembly.
3. Remove three screws, nuts and backing plate from the
left footrest.
4. Remove screws, retainer clips, and cable tie from PVT
air outlet duct, Remove outer cover.
5. Mark the drive belt direction of rotation and remove
drive belt. The belt is normally installed so the
numbers can be easily read. To remove drive belt,
apply brake, pull upward and rearward on belt to open
driven clutch sheaves, push down on belt to hold
sheaves open, and slip belt over driven clutch outer
sheave.
6. Remove drive clutch retaining bolt and remove drive
clutch using puller.
7. Remove driven clutch retaining bolt and driven clutch
using puller.
8. Remove driven clutch offset spacers from the
transmission input shaft.
Polaris Industries Inc.
6.9 7/96