9.
Remove the reservoir cap carefully with a pliers.
10. Remove bleeder screw from internal floating piston (I FP)
using IFP Holding Tool (PN 2871351) and a
1/8"
hex
wrench. To remove IFP from reservoir, install holding
tool, rotate tool 114 turn, and pull the piston slowly
upward.
Be prepared to catch IFP piston ring when
piston is remove from reservoir.
11. Using a
1/1
wrench, loosen shaft bearing cap.
NOTE:
If
the shock body starts to unscrew from the reservoir
casting, install body holding tool (PN 2871071). Position
the tool approximately 1
1/2"
below the bearing cap as
shown, tighten securely in the vise and loosen the
bearing cap.
Polaris Industries Inc.
5.31
BODY AND STEERING
FOX™
Shock Service
7/96