Front Drive Shaft CV Joint Boot Replacement (4x4 Models)
1.
Removewheel, brake caliper and wheel hub. Refer
to front hub disassembly page 7.4 for procedure.
2.
Remove cotter pin and castle nut from A arm ball
joint.
3.
Disconnect A-arm from ball joint.
4.
Slide strut off end of drive shaft and tie it up out of
the way of the shaft.
NOTE: Be careful not to damage the wheel coil wires
when positioning the strut.
5.
Remove clamps from rubber boot using the proper
boot clamp pliers.
6.
Remove the large end of the boot from the CV joint,
slide the boot back and remove the wheel spindle
and CV joint assembly by pulling it sharply outward,
away from the axle. It may be necessary to tap the
CV joint assembly outward with a soft faced
hammer.
7.
Remove small clamp and boot from driveshaft.
Polaris Industries Inc.
7.11
FINAL DRIVE
Drive Shaft Boot Replacement
7/96