FINAL DRIVE
7. Apply Loctite® 603™ retaining compound to the
outer circumference of the new bearing race
carefully press the new bearing into the bearing
e
carrier housing
.
NOTICE
Use care to not allow any of the Loctite® compound to
get in the bearing.
8. Wipe the housing clean of any excess compound and
r
install the snap ring
8.8
w
.
REAR BEARING CARRIER
and
INSTALLATION
1. Install drive shaft through the back side of the bearing
carrier.
2. Install the fasteners
lower control arms to the bearing carrier. Torque bolts
to specification.
Rear Bearing Carrier Mounting Fasteners:
3. Apply a small amount of anti-seize to the drive shaft
splines.
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
q
that attach the upper and
TORQUE
42 ft-lb (57 Nm)
© Copyright Polaris Industries Inc.