Switch Testing; Key Switch/Auxiliary Shut Off (Kill) Switch; Starter Switch; Override Button - Polaris Magnum 2x4 Service Manual

Polaris atv and light utility vehicle service manual
Table of Contents

Advertisement

ELECTRICAL
Switch Testing
Most of the switches on the vehicle can be tested at the terminal board or at the harness connectors located under
the front panel (Gen 111/ Gen IV) or tank cover (Gen II). To access the terminal board or connectors:
-Remove seat and top fuel tank cover (Gen
II
models). Refer to Chapter
5.
-Remove front rack (if equipped) and front cover under headlight (Gen
III
& Gen IV models). Refer to Chapter
5.
Key Switch/Auxiliary Shut Off (Kill) Switch
Turn key (and engine stop switch) "ON" and check for battery voltage on RedlWhite terminal or harness side of
connector. If battery voltage is present, switch function is O.K. Disconnect switch wires at terminal board or con-
nector. Check continuity of wires in each switch position. Continuity should exist between color coded wires as
sh
h
h
b I
own in t
IE C
art el( w.
Blk
Brn
RIW
R
Off
-
-
...
...
-
-
On
-
-
"Off"
Continuity between Black and Brown wires. No continuity between RedlWhite and Red wires.
"On"
Continuity between RedlWhite and Red wires. No continuity between Black and Brown wires.
Starter Switch
Check starter switch at terminal board or at the harness connector. Terminal boards - Disconnect the White/Red
wire from the switch at the panel. Turn key (and engine stop switch) "ON", The wire should show battery voltage
when the starter button is depressed. Connector style harness - perform continuity test below with coupler discon-
nected.
Continuity Test" Turn key off. Disconnect RedlWhite and White/Red switch wires at terminal board or connector.
Continuity should exist between color coded wires as shown in the chart below.
RIW
Free
Pushed
W/R
Replace the switch if resistance is indicated or if voltage drop is greater than .1 DCV.
Override Button
Disconnect the Purple, GraylWhite, and Green wires at the terminal board or connector. Continuity should exist
between color coded wires as shown in the chart below. Make sure to verify no continuity as well as continuity.
Pur
Gryf\N
Grn
Free
-
-
-
-
Pushed
-
-
...
...
12/97
10.38
Polaris Industries Inc.

Advertisement

Table of Contents
loading

Table of Contents