Indicator Lamp Service; Taillight/Brakelight Lamp Replacement; Indicator Lamp Replacement (Gen Ii, Gen Iii And Gen Iv) - Polaris Magnum 2x4 Service Manual

TaillightlBrakelight Lamp Replacement
If the taillight/brakelight does not work the lamp may need
to be replaced.
1. From the rear of the taillight remove two screws hold-
ing lens cover in place and remove lens cover.
2. Remove lamp and replace it with recommended lamp.
Apply dielectric grease PN 2871027.
3. Reinstall the lens cover removed in step 1.
4. Test the taillightlbrakelight to see that it's working.
Indicator Lamp Replacement (Gen II)
1. With a small, flat screwdriver gently pry loose the indi-
cator light cover.
2. Using a small flexible tube (such as an oil delivery
hose) grasp the burned out lamp and remove it.
3. Replace the removed lamp with a Polaris PN
4030042.
4. Replace the indicator light cover.
NOTE: Check all lights daily for proper operation replace
or repair
if
necessary.
Indicator Lamp Replacement (Gen III and Gen IV)
1. Follow steps 1 - 3 of Headlight Housing Replacement
above.
2. Unplug light from harness, depress locking tabs and
remove from pod.
3. Install new light and reassemble pod.
Polaris Industries Inc. 10.9
Bulb
ELECTRICAL
Indicator Lamp Service
,
~over
Jrj
~/,
Depress locking
tabs to remove.
7/96