6X6 Middle Axle Brake Pad Assembly - Polaris Magnum 2x4 Service Manual

BRAKES
6x6 Middle Axle Brake Pad Replacement
Assembly
1. Install brake pads in caliper body so they are facing each
other. Hold brake pads in place and install retaining pin.
2.
Slowly pump the brake lever until pressure has been
built up. Maintain at least
1/2"
(12.7 mm) of brake fluid
in the reservoir to prevent air from entering the brake
system.
3. It is recommended that a burnishing procedure be
performed after installation of new brake pads to extend
service life and reduce noise. Start machine and slowly
increase speed to 30 mph, gradually apply brakes to stop
machine. Repeat procedure 10 times.
Polaris Industries Inc. 9.15
7/96