Final Coolant Draining/Engine Removal - Polaris Magnum 2x4 Service Manual

ENGINE
EH42PL/EH50PL Engine
Removal, Cont.
17. Loosen nut on slotted rear engine mount plate and
back it out to the end of the stud.
Final Coolant Draining/Engine Removal
1 . Move top of engine to left until the coolant supply hose
clamp clears the frame at the water pump fitting.
2. Lift and twist engine clockwise until the lower left
engine mount stud is clear of the frame mount and the
lower right coolant hose clamp clears the frame tube.
3. Support engine in this position with a suitable support,
such as a board or a 2x4.
4. Place a drain pan beneath area to catch coolant.
5. Clamp coolant inlet hose leading from radiator to pump
to reduce coolant spillage.
6. Loosen hose clamp on upper water pump outlet
coolant hose and remove hose, draining engine
coolant into container. NOTE: Remove plug in
thermostat housing to increase flow.
7. Reinstall hose and clamp.
8. Remove hose from water pump inlet and place in
container. Release clamp from hose and allow hose to
drain completely.
9. Lift back of engine while rotating front of engine
clockwise and remove engine from left side of frame.
7/96 3.42 Polaris Industries Inc.