Rear Hub Disassembly (Shaft Drive) - Polaris Magnum 2x4 Service Manual

Rear Hub Disassembly (Shaft Drive)
1. Remove outer snap ring.
2. From the back side, tap on the outer bearing race
with a drift punch in the reliefs as shown.
NOTE:
Drive bearing out evenly by tapping on outer
race only. Once bearing is at bottom of casting, support
casting on outer edges so bearing can be removed.
3. Inspect bearing.
NOTE:
Due to extremely close tolerances and mini-
mal wear, the bearings must be inspected visually, and
by feel. While rotating bearings by hand, inspect for
rough spots, discoloration, or corrosion. The bearings
should turn smoothly and quietly, with no detectable
up and down movement and minimal movement side-
ways between inner and outer race.
4. Inspect bearing housing for scratches, wear or
damage.
Polaris Industries Inc.
7.28i
FINAL DRIVE
Rear Hub - Shaft Drive
10/96