Rear Bearing Carrier Installation - Polaris RZR XP 1000 2014 Service Manual

Table of Contents

REAR BEARING CARRIER INSTALLATION

1. Install drive shaft through the backside of the bearing

2. Install the four fasteners

bearing carrier to the trailing arm. Install the one

that attaches the upper radius rod to the

bearing carrier. Torque bolts to specification.

Use new nuts upon installation of the rear bearing

Bearing Carrier to Trailing Arm Bolts:

42 ft-lb (54 Nm)

Radius Rod to Bearing Carrier Fasteners:

40 ft-lb (54 Nm)

3. Apply anti-seize to drive shaft splines.

that attach the rear

4. Install rear wheel hub assembly

and hand tighten the castle nut. Install washers with

domed side out.

5. Install the rear brake caliper assembly and new bolts

. Torque to specification.

Rear Caliper Mounting Bolts:

40 ft-lbs (54 Nm)

9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual

, cone washers

Table of Contents