2x4 Front Hub Installation
1.
Apply grease to washer and install with spindle
nut. Torque nut to 40 ft.lbs. (5.52 kg-m) and install
cotter pin. Tighten nut slightly if necessary to align
cotter pin holes.
Rotate wheel and check for
smooth operation. Bend both ends of cotter pin
around nut in opposite directions.
2.
Inspect O-Rings on hub cap for wear, cracks or
damage and replace if necessary.
3.
Apply a light film of grease to hub cap and install
until fully seated.
Polaris Industries Inc.
7.23
FINAL DRIVE
2x4 Hub Bearing Service
7/96