Installation (Typical)
15. Grease support bearing and install on output shaft.
16. Slide output shaft support bearing inward against
frame. Be sure to hold bearing square with shaft.
17. Visually inspect gap between frame and upper or
lower mounting boss on support bearing. If a gap
exists on upper or lower boss, measure with a feeler
gauge and add shim(s) as required to maintain
proper alignment when mounting nuts are tightened.
Torque to specification.
18. Apply silicone to splines of brake disk and reinstall
disk.
19. Install brake caliper on disk and bolt to frame with the
rear caliper shield. Torque to specification.
Polaris Industries Inc.
8.17
TRANSMISSION SERVICE
Type III, EZ-Shift Transmission
10/96