Polaris Magnum 2x4 Service Manual page 539

BRAKES
Front Caliper
Installation Cont.
2. Install brake line and tighten securely with a line
wrench.
3. Install the adjuster screw and turn until stationary pad
contacts disc, then back off 112 turn.
4. Follow brake bleeding procedure outlined on page
9.4.
5. Install wheels and torque wheel nuts to specification.
NOTE: If new brake pads are installed, it is recommended
that a burnishing procedure be performed to extend pad ser-
vice life and reduce noise. Start machine and slowly in-
crease speed to 30 mph, gradually apply brakes to stop ma-
chine. Repeat procedure 10 times.
7/96 9.24
Polaris Industries Inc.