Polaris Magnum 2x4 Service Manual page 63

MAINTENANCE
Lubrication Chart
12. Tie Rod
End
/
8. Front
Wheel
Bearings
(2x4 Models)
10. Ball Joint
9. Front Drive Axle
U-JOi~t~,
'--:,~
J
~"
..
13. Counter-
balance dipstick
III. Item
#
7 Demand 4 Hubs -
All Wheel Drive
ATVs
8
Front Wheel Bear-
ings - Non - driving
front wheels
9
Front Drive Axle "U"
Joints
10 Ball Joint
11 Front A-Arm Pivot
Shaft
12 Tie Rod Ends
13 Counter Balance
Housing (400L)
14 Steering Post Bush-
ings
5/98
Lube Rec.
Polaris Demand
Drive Hub Fluid or
ATFType F
Sealed; Replace
Polaris U-Joint
Grease**
Polaris All Season
Grease**
Polaris All Season
Grease**
Polaris All Season
Grease
u
10W30 Motor Oil
All Season
Grease**
12. Tie Rod End
(4x4 Models)
7. Demand 4 Hubs
4 or 8 O'clock position-
(end view)
/
11. Front A-Arm
Pivot Shaft
10. Ball Joint
Method
Remove filler hole screw in hubs. Rotate wheels to
4 or 8 O'clock position. If lubricant is not visible add
until it flows from filler hole screw. Reinstall screw.
Inspect and replace bearings if necessary
Locate grease fitting and grease with grease gun.
Locate grease fitting on back side of struts and
grease with grease gun.
Locate grease fitting on pivot shaft and grease with
grease gun.
Locate grease fitting and grease with grease gun
(where applicable. On others: Lift boot. Clean
away dirt and grease. Apply fresh grease by hand
and reassemble.
Check level on dipstick and add oil as necessary.
Change annually. To change oil see page 2.21.
Locate fittings on upper and lower steering post and
grease with grease gun.
Frequency*
Semi-annually
ITJ
Annually [l]
Semi-annually
ITJ
Semi-annually
ITJ
Semi-annually
ITJ
Semi-annually
ITJ
Change
Annually
[l]
Semi-annually
ITJ
2.6 Polaris Industries Inc.