Awd Armature Plate Inspection; Awd Front Drive Axle Removal - Polaris 2004-2005 Sportsman 6x6 Service Manual

2870888) and into the groove of the rollers and
cage. WARNING:
followed the spring will be over stressed and lose
its tension. Springs with incorrect tension may
allow rollers to move outward at high vehicle
speeds. If the rollers move outward, the front
hub(s) will engage and cause vehicle instability,
which could result in serious injury or death.
Must use Hilliard Clutch Garter
Spring Installation Tool
(PN 2870888)
WARNING: Be sure to use correct garter spring.
These springs are very similar in appearance to those
used on earlier models. If the old, lighter springs were
installed on a machine requiring the heavier spring,
the front wheels may engage at high speed, possibly
resulting in serious injury or death. Check springs
before installation. Always verify the correct
replacement spring part number by referring to
the appropriate parts manual.
8. Current electro-mechanical
3250032); wire diameter .018" (.46 mm); spring
free length end to end inside hooks 6.968" (177
mm).
Measure wire diameter
Measure free length to inside of
loops as shown
7.8
If this procedure is not
spring, (PN
GENERAL INFORMATION
AWD ARMATURE PLATE
INSPECTION
Seal Sleeve
Armature Plate Tabs
1. As the armature plate is engaged, it should
contact the outer magnet pole (seal sleeve) and
the inner magnet pole. Also, the armature plate
must be flat when placed on a flat surface. Bent
armature plates should be replaced.
NOTE: It is not unusual to see a double wear ring
on the armature plate; however, the wear rings
should be even.
2. Install the roller clutch (Hilliard Clutch) assembly
and be sure the armature plate (A) is positioned
properly. Also, when installing the hub assembly,
be sure the armature plate tabs remain engaged
with the roller clutch cage.
CAUTION: After the hub is installed, the slightest
movement outward with the hub may cause the
armature plate tabs to disengage from the roller clutch
cage. If the unit is driven with the armature plate out
of position, it will cause roller clutch damage.
AWD FRONT DRIVE AXLE
REMOVAL