Outbound Ip Connection - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

With Version 8000 or higher software, PCPro and WebPro have been enhanced allowing

T1/ISDN layer 1 status, System Alarms and SRAM information to be viewed. The SRAM

displays Day/Night Mode information, Trunk information (Trunk to Trunk Transfer Set/Not

Set, Trunk disabled), Read List, Department Group information (DND, Transfer settings)

and Extension information (Forwarding settings, Alarm settings, DND, BGM and more).

This feature requires Version 8000 Enhanced (0037) license and Maintenance (0043)

Refer to the UNIVERGE SV8100 PC Programming Manual, Appendix L, Maintenance Features for more

With Version 9000 or higher software, WebPro has been enhanced to allow for remote

upgrade and is only available in the Manufacture (MF) and Installer (IN) level logins.

With Version 9000 or higher software, WebPro has been enhanced to allow for Backup of

the system data and also the restoring of a Backup.

Backup data is in the GZIP (.gz) format.

Backup is not able to be modified.

When the Backup is restored, the system resets after the upload is completed.

Only available in Manufacture (MF), Installer (IN), and System Administrator 1 (SA1) level

Outbound IP Connection

Outbound IP Connection for PC Programming allows the system to make

outgoing call over IP, to a pre-programmed IP Address, upon receipt of an incoming CO call matching a

pre-programmed CLI. When the target number of DID incoming call matches with the service code of

'Outbound IP Connection' the SV8100 compares the received CLI with the registered CLI (Program

90-69-03). When the received caller ID and registered caller ID match, the SV8100 sends a TCP

establishment request to a waiting PCPro application. When the caller ID does not match, the call will

either step to the locations in Program 22-11-05 and Program 22-11-06 if configured or, send a busy tone

to the caller. Alternatively, via dialing service code from a Multiline Terminal, an outgoing IP connection

can be made to a waiting PCPro terminal with a pre-programmed IP Address. This allows for a

pre-authorized connection for programming purposes without using CO Lines and potentially reducing

the cost of calls for maintenance. The outgoing IP call connects by sending a TCP establishment request

to a waiting PC Programming terminal. A fixed, encrypted, user ID and password are used to verify the

If an unsuccessful connection attempt is made, this can be output as an alarm.

UNIVERGE SV8100

a PC Pro Connection via

PC Programming