Table 2-57 Restrictions For Calling Party Names - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Features and specifications manual (2148 pages)

Features & specifications manual (1174 pages)

Programming manual (986 pages)

Table of Contents

UNIVERGE SV8100

Speech and 3.1 KHz audio

PRI ability requires the installation of CD-PRTA. Each PRI circuit provides 24 PRI channels

(23B + D) 4 with 64K Clear Channel response. The T1/PRI Interface uses a single slot.

When installed, the T1/PRI Interface uses the first block of 24 consecutive trunks. For

example, if you have an

automatically uses trunks 9~32. If you have

and 17~24, the T1/PRI uses trunks 25~48. The T1/PRI Interface cannot use trunks 9~16

(even if available) since they are not part of a consecutive block of 24 trunks.

The sending of Calling Party Name display information to the public network with ISDN PRI

is only supported with NI2 protocol.

When using Mobile Extension in a NetLink Network, the ISDN/PRI must be utilized in the

Primary System.

When using fractional PRI, the blade comes up as zero ports until Program 10-03-06 is set

to the 4/8/12/16/20/24(auto), and then reset.

If fractional PRI has the number of ports changed, the Trunk Port number might change if

they become split or fit into an empty gap of trunk ports. For example, if you have a

CD-4COT + PZ-4COT

as 25~36 and the PRI is changed to be eight ports instead of 12 ports, the new trunk port

numbers would be 9~16 because the eight ports can now fix into the gap without being split

ports. Another example, if you have a

and the PRI (8 ports) was assigned as 9~16 and then you change the PRI to be 12 ports

instead of eight, the new trunk ports would be 25~36 because the ports have to be split to

keep the original port numbers, and this is not supported.

If using a CSU/DSU, Program 10-03-13 must be set to 0. If not using a CSU/DSU,

Program 10-03-13 must be set to 1~7 or anything other than 0.

Restrictions for Calling Party Name:

The UNIVERGE SV8100 supports receiving the name from the Network in supported

formats only. Refer to

4ESS (AT&T Custom)

AT&T5ESS Lucent Custom

DMS-100 (Custom)

DMS-100 (National; ISDN)

Nortel Specification NIX-A211-1

ISDN Compatibility

CD-4COT + PZ-4COT

for Trunks ports 1~8 and 17~24 and the PRI (12 ports) was assigned

Table 2-57 Restrictions for Calling Party