NEC Univerge SV8100 Features And Specifications Manual page 1285

UNIVERGE SV8100
Disk Space
TCP Port
Screen Resolution
The hardware/software requirements for the host PC running WebPro are:

Browser
Network
Screen Resolution
You can have a maximum of four users logged into WebPro anytime.

You can have up to two phones in programming mode anytime.

You can have four WebPro users and two phone programming users logged in at the same

time for a total of six users in programming mode simultaneously. However, the two
phone programming users do not show up in session management in WebPro.
PCPro can be logged in with only one user. This is allowed only if no other users are

logged into programming mode (PCPro, WebPro, or Phone). Also, if a user is connected to
the switch via PCPro, no other user can log in through PCPro, WebPro, or Phone
Programming.
Only one PCPro/WebPro/Handset can be programming the switch anytime.

When programming via WebPro/PCPro, some data requires you to logout before the switch

fully applies the changes. These Programs are: 10-21-2, 11-02 (for directory dial), 11-04
(for directory dial), 13-04 (for directory dial), 14-04, 15-05, 15-15, 16-02, 23-02, 31-02,
41-02, 41-17, 47-02, 47-03, 82-11 and 83-11.
PC Programming
Item
35MB for PCPro (minimum)
TCP port 8000 must be open between the
terminal and the host PC for uploading/
downloading via LAN. PCPro/WebPro TCP port is
set for 8000 at default, but can be changed via
WebPro using Program 90-38-02. Program
90-38-02 is not accessible from Phone
Programming or PCPro. TCP port 5963 is
required to be open if the Debug Terminal is going
to be used.
800 x 600 (minimum)
1024 x 760 (recommended)
Item
MS Internet Explorer 6.0 (or higher)
IP connection to the KTS
800 x 600 (minimum)
1024 x 760 (recommended)
Requirement
Requirement
Issue 13.0
2 - 1251