NEC Univerge SV8100 Features And Specifications Manual page 928

Issue 13.0
Program
Program Name
Number
21-19-01 IP Trunk (SIP) Calling Party
Number Setup for Extension
22-02-01 Incoming Call Trunk Setup
44-02-01 Dial Analysis Table for ARS/
F-Route Access – Dial
44-02-02 Dial Analysis Table for ARS/
F-Route Access – Service Type
44-02-03 Dial Analysis Table for ARS/
F-Route Access – Additional
Data
2 - 894
Description/Comments
Assign the Calling Party Number
for each extension. The assigned
number is sent to the central office
when the caller places an outgoing
call. If the Calling Party Number is
assigned by both Program 21-17
and Program 21-18/Program
21-19, the system uses the data in
Program 21-18/Program 21-19.
Assign the incoming trunk type for
each trunk.
For the SIP System

Interconnection, set each
trunk to 5 (E&M Tie Line).
Set the Dial digits for the Pre-
Transaction Table for selecting
ARS/F-Route (eight digits
maximum: 1~9, 0  #, @).
To enter a wild card/don't

care digit, press Line Key 1 to
enter an @.
Set the Service Type (0~3) for the
Pre-Transaction Table for
selecting ARS/F-Route.
For the SIP System

Interconnection, set each
Dial Digit to 2 (F-Route).
This is the F-Route Table set in
Program 44-05.
IP Trunk – (SIP) Session Initiation Protocol
UNIVERGE SV8100
Assigned Data
1
Up to 16 Digits
#
(1~0, , )

(default not assigned)
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID

4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
Up to eight digits
(default not assigned)

0 = No Setting (None)
1 = Extension Call
(Own)
2 = ARS/F-Route Table

(F-Route)
3 = Dial Extension
Analyze Table (Option)
(default = 0)
1 = Delete Digit =
0~255 (255 : Delete All
Digits)
2 = 0~500
(0 = No Setting)

3 = Dial Extension
Analyze Table Number
= 0~4
(0 = No Setting)
(default = 0)
Level
2 3
