NEC Univerge SV8100 Features And Specifications Manual page 1394

Issue 13.0
Program
Program Name
Number
35-02-23 SMDR Output Options – Watch
Auto Dialing
90-10-01 System Alarm Setup – Alarm
Type
90-10-02 System Alarm Setup – Report
90-20-11 Traffic Report Data Setup –
Security Sensor Dial Record
Operation
Warning Message (Watch Mode):
< Program >
Program 11-10-20: (616) Record, Erase VRS message SC616
Program 11-10-46: (614) Watch message setting
Program 11-12-63: (717+1/0) Watch Mode Start/Stop
Program 15-07-01: Set
Program 20-44-01: (1) Internal paging group, 1
Program 20-44-02: (1) External paging group, 1
Program 20-44-03: (1) VRS message number for watching, 1
Program 20-44-04: (5) Interval time of Watching message, 5 minutes
Program 20-47-01: (1) Watch mode time pattern, 1
To record Watching message to VRS 001
1. Press Speaker and dial 616 + 7 + 001.
2. After the beep, record message.
3. Press Speaker to hang up.
2 - 1360
Select whether the system should
display the WAD (Warning Auto
Dialing) on SMDR report.
Set the alarm type 31, 32, 33.
Alarm 31 – Auto dialing after
sensor detection.
Alarm 32 – Auto Dialing for
Remote Watch function.
Alarm 33 – Fail to auto dialing of
security function.
Assign whether or not the alarm
information is reported to the
predefined destination in Program
90-11.
Assign whether or not the security
sensor dial report is recorded for
Record Security sensor dialing
and Remote Inspection dialing.
32 to Function key

Description/Comments
UNIVERGE SV8100
Assigned Data
1
SMDR Port 1-8:
0 = No Output
1 = Output
(default = 0)
0 = Not Set
1 = Major Alarm
2 = Minor Alarm
(default = 0)
0 = No Report (no
autodial)
1 = Report (autodial)
(default = 0)
0 = Not Record
1 = Record
(default = 0)
Level
2 3




Security