Table 2-42 Example - Required Ip Terminal Settings; Table 2-43 Example - Sv8100 System Router A Port Forwarding Settings - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

10020 ~ 10083 (UDP)

Port forwarding does not need to be assigned at the Remote Terminal location.

With Version 9000 or higher software, improvements have been made to the NAPT Feature.

Previously, when the DT700 connected to the system via NAPT, the intermediate router/firewall could

possibly close the port due to inactivity for a period of time. The solution for this was to lower the

Registration and Subscribe expiry timers. However, these timers were system wide and would affect all

terminals (not just NAPT terminals), causing an increased network and CPU load. To correct for this

issue, Version 9000 or higher added these timers on a per station basis. This way the NAPT terminals

can lower the timers and not affect all the Non NAPT terminals. No new licensing is required for this

feature; all existing licenses are still required.

IP Multiline Station (SIP)

Table 2-41 Example – Required System Settings (Continued)

Table 2-42 Example – Required IP Terminal Settings

Default Gateway

NAT Traversal Mode

WAN Mate IP Address

WAN SIP Mate Port

Table 2-43 Example – SV8100 System Router A Port Forwarding Settings

IP Address Port is Forwarded To

NAT RTP send port choice

(Version 6000 or higher required)

VOIP DSP IP Address

172.17.0.100

172.17.0.254

Signaling port and must be forwarded

to the IP Address assigned in

Program 10-12-09.

Secondary signaling port and must

be forwarded to the IP Address

assigned in Program 10-12-09.

Voice ports and must be forwarded to

the IP Address assigned in Program