NEC Univerge SV8100 Features And Specifications Manual page 1150

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

Issue 13.0
Analog CID
Analog CID
ISDN PRI/SIP
ISDN PRI/SIP
Conditions
It is recommended that this feature use ISDN/SIP platform (as these trunks provide answer
supervision).
If an extension has Call Forward-Both Ring set to a Mobile Extension (twinning), it will not
forward to VM or anywhere else (Version 2500 or lower software).
If the extension has Call Forward-Both Ring set to a Mobile Extension (twinning), it can only
forward to VM (NA or B/NA) and nowhere else (Version 3000 or higher software is
required).
If an extension has Call Forward-Both Ring set to a Mobile Extension (twinining), it will not
forward when the Mobile Extension is forwarded All or B/NA (Busy Immediate).
ISDN and SIP trunks are only supported for the outbound call to the Mobile Extension
(Version 2500 or lower software).
Analog, ISDN and SIP trunks are supported for the outbound call to the Mobile Extension
(Version 3000 or higher software is required).
The analog line must provide calling line identification information to allow the Mobile
Extension to dial into the system to access features.
For the extension DTMF, the minimum Detect Level for the DTMF Tone (Program
80-03-03) must be set to allow a minimum detection level of -25dBm. This entry is
dependent on the Detect Level selected in Program 80-03-01.
The Mobile Extension uses the * to perform a flash, so any service codes which
begin with * must be changed (Programs 11-10, 11-11, 11-12, 11-13).
To provide a proper disconnect, Disconnect Supervision is required for the trunks
used for this feature.
When an entry is made in Program 15-22-01 for a Mobile Extension, ports are reserved for
Mobile Extension usage in groups of 2.
To keep consecutive port numbering for blades, you may wish to consider starting Mobile
Extensions at the upper extension port range.
The incoming Caller ID for a call that is forwarded to a mobile extension will not be
presented to the Mobile Extension (Version 2500 or lower software).
2 - 1116
Table 2-74 Caller ID Sent to Mobile Telephone (Continued)
Inbound Trunk
CFNA Analog
CFNA ISDN PRI/SIP
CFNA ISDN PRI/SIP
CFNA Analog
Outbound Trunk
UNIVERGE SV8100
Y/N
N
Y
Y
N
Mobile Extension

Advertisement

Table of Contents
loading

Table of Contents